Instructions

AP UI
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 98
Wireless Bridge Configuration:
A point-to-point wireless bridge is used to connect LAN(s), which are often in different buildings, through
the wireless interface. The wireless bridges eliminate the need for expensive leased lines and fiber-optic
cables.
Navigate: AP-UI -> Network -> AP Interface -> AP Interface Configuration.
Edit the Backhaul1/Connector1 interface to complete the wireless bridge configuration. Either Backhaul1
configuration or Connector1 configuration is sufficient. The last saved configuration will be effective if
Backhaul1 and Connector1 are configured with different attributes:
• Enable – Enable/disable the wireless bridge on the AP.
• Mode – AP working mode, mesh mode or bridge mode.
• SSID – WLAN used to setup wireless bridge connection.
• Band – Wireless bridge working frequency.
• Is Root – Specify the root node of the wireless bridge.
• Passphrase – Password of the WLAN used to setup wireless bridge connection.
• Confirm – Re-enter the password to confirm.
Figure 9-8 Configure Wireless Bridge
Note:
1. AP1201, AP1201L, AP1201H, AP1201HL is low performance than other mid-end/high-end APs, and
those APs do not support bridging the packets with VLAN tags, so not recommend deploying
wireless bridge with above AP models. If really needs to deploy wireless bride with AP1201,
AP1201L, AP1201H, AP1201HL, please contact ALE support for help. AP1201, AP1201L, AP1201H,
AP1201HL is working correctly in MESH deployment.