Instructions

Introduction to the AP Group Web Management System
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 54
Table 4-15 ACL Parameter Specification
Parameter
Specifications
Source IP
The source IP address.
Destination IP
The destination IP address.
Source Port
Source UDP or TCP port.
Destination Port
Destination UDP or TCP port.
IP Protocol
There are three options for IP Protocol, TCP, UDP or ICMP.
Action
Accept or Reject
Apply To WLAN
Indicate the range which the ACL rule take effect for wireless connection,
specific SSID or any SSID.
Apply To
EthPort
Indicate the range which the ACL rule take effect for downlink wired connection,
dedicated for AP1201H.
Note 4-8: Stellar AP supports L2 ACLs, you can blacklist/white-list certain MACs or a range of MAC
addresses, see Blacklist & Whitelist Window. Also, you can setup rules based on 802.1p/DSCP while creating
a new SSID, see Modify WLAN QoS.
Network Page
The Network page is mainly focus on wired network configuration. For example, user can view and
configure AP1201H downlink ports in network page.
Figure 4-48 Network Page
The AP1201H downlink configuration template is always displayed in the Web-UI, even when there is no
AP1201H in the cluster. If there isn’t any AP1201H in the AP Group, you don’t need to change this
configuration.
Table 4-16 Wired Network
Parameter
Specifications
AP Model
AP model needs to configure wired link
Ethernet
Ethernet port of AP
VLAN ID
VLAN ID assigned to the Ethernet port