Instructions

Introduction to the AP Group Web Management System
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 22
Restore factory settings for all the APs in the group.
Backup the configuration of the AP group.
Restore the configuration for the AP group.
Update the firmware for all the APs in the group.
• Contact to Cloud – Enable/Disable contacting to OmniVista Cirrus
periodically. If AP in the cluster are authorized to register OV Cirrus,
the AP will reboot the register to OV Cirrus, then user can monitor
and manage the AP from OV Cirrus. By default, it is enabled.
• Management Server – OV Cirrus server address to which AP send
the register request. User can modify the management server
address for the purpose of using other OV Cirrus server than the
default one.
Convert all the APs in the cluster to be managed through OmniVista On-
Premise. Once configured, AP will reboot and register to On-Premise OV
server.
• Management Server – OV On-Premise server address to which AP
register. DHCP Option – Obtain the On-Premise OV server address
through DHCP option 138 or option 43 during AP booting up state.
Static – Configure a static On-Premise OV server to which AP will
register after rebooting.
Detailed information for the selected AP.
AP Name
Name of the AP.
Location
Location of the AP.
Status
Connection status of AP, there are three indications for AP status, they
are Working, Down and Joining. See more in Note 4-2.
Remove the AP from the group. When an AP is removed from the group, it
changes into Joining state until the administrator permits it to join the
group again. See more in Allow an AP to Join the Group.
Role in Group
AP role in the group, including PVM, SVM and Member.
Update to PVM
Upgrade the member or SVM to be the PVM of the AP group.
Serial Number
Serial Number of the AP selected.
Model
Product Model of the AP selected.
Upgrade Time
Last firmware upgrade time.
Upgrade Flag
Flag of last time firmware upgrade. Success means the firmware was
upgraded successfully on the Upgrade Time, Failed means the firmware
wasn’t upgraded successfully on the Upgrade Time.
IP Mode
The way by which the AP attains its IP address, dynamically assigned from
DCHP server or static IP configured manually. Only IPv4 static address can
be configured for AP.
IP
IPv4/IPv6 address of the AP selected.
Netmask
Netmask of the IPv4 address of the AP selected.
Default Gateway
Default Gateway of the AP selected.
DNS
DNS server in the network.
AP Mode
• Express – AP working in cluster mode.
• Enterprise – Change the AP to be managed and configured through
OmniVista On-Premise edition. You need to specify the OmniVista
server address when changing to Enterprise mode. DHCP Option –
Obtain the On-Premise OV server address through DHCP option 138
or option 43 during AP booting up state. Static – Configure a static
On-Premise OV server to which AP will register after rebooting.