Instructions

AP UI
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 100
• Assign – IP addresses have been allocated.
• Network – Network to which the DHCP pool is bound. A Network usually means the VLAN mapping
to specific SSID or the AP WAN interface. All the networks are displayed in the window: AP UI ->
Network -> AP Networks. You must map the VLAN to a SSID before it can be displayed in the AP UI.
• Lease Time – Period of time that the IP address allocated can be used by the device. By default,
lease time is 24 hours.
• Subnet – Subnet of the DHCP pool.
• Gateway – Specify the gateway for the DHCP pool.
• Range Start – DHCP pool starting IP address.
• Range Stop – DHCP pool ending IP address.
• DNS1 – Primary DNS server for the DHCP pool.
• DNS2 - Secondary DNS server for the DHCP pool.
• Operate
o Bind Network – Bind the DHCP pool to specific Network. Before binding, you need to
configure the Network basic parameters in the ‘AP UI -> Network -> AP Networks window’.
Only Network with static IP (as gateway) can be bound to a DHCP pool.
o Delete – Delete the DHCP pool.
o Leases – Display the IP addresses which have been allocated to devices.
Configure DNS Cache through AP UI
Navigate: AP-UI -> Service -> DNS.
• Cache Size – Specify the size for the DNS cache.
Configure NAT through AP UI
Navigate: AP-UI -> Service -> NAT -> Source NAT.
Source NAT
Figure 9-11 Source NAT
Source NAT can be utilized to translate the internal IP addresses to single external IP address while visiting
Internet, by saving public IP address.
• Name – Name of the Source NAT rule.
• Source IP – Mapping source IP address of the NAT rule, single IP or segment.