User's Manual

3/16/04 Step 4: Mounting the OmniAccess APs
90-100832-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 19
Figure - Assembling the Mounting Screws and Spring Washers to the OmniAccess AP
• Copy the MAC address(es) from the label(s) on the OmniAccess AP onto the corresponding
location on the map. MAC addresses have the format 000B85xxxxxx.
• You have already attached the projection-mount L-bracket to the wall in Step 3: Preparing
Mounting Locations.
• Slide the screws into the keyhole slots on the mounting bracket as shown in the following
figure.
Note: If the screws do not securely hold the bracket, remove the OmniAccess AP and adjust
the screws until they securely hold the bracket.