Network Card User Manual

Web Interface
3-6
Main Menu
Using the onboard Web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The interface
screen includes the main menu on the left side, the menu bar beneath the image of
the switch, and a list of commands beneath the menu bar. The following table briefly
describes the selections available from this program.
Function Description
System Provides basic system description, including contact information.
Switch Shows hardware/firmware version numbers and power status of the switch.
IP Includes boot state, IP address, and Telnet session count.
SNMP Configures communities and trap managers; and activates traps.
Security Sets password for system access.
Upgrade Downloads new version of firmware to update your system.
Configure Saves the switch configuration to a file on a TFTP server. This file can be later
downloaded to restore the configuration
Address Table Provides full listing or unicast addresses, sorted by address or VLAN.
STA Enables Spanning Tree Algorithm; also sets parameters for switch priority,
hello time, maximum message age, and forward delay; as well as port priority
and path cost.
Bridge Extension Displays/configures extended bridge capabilities provided by this switch,
including support for traffic classes, GMRP* multicast filtering, and VLAN
extensions.
Priority Configures default port priorities and queue assignments.
VLAN Configures VLAN group members, automatic registration with GVRP*, and
other port-specific VLAN settings.
IGMP Configures IGMP multicast filtering.
Port Enables any port, sets communication mode to auto-negotiation, full duplex
or half duplex, and enables/disables flow control.
Mirror Sets the source and target ports for mirroring.
Trunk Specifies ports to group into aggregate trunks.
Statistics Displays statistics on network traffic passing through the selected port.
* Not implemented in the current firmware release.