Network Card User's Manual

Alcatel OmniAccess 6000 LC-2G24FP Installation Instructions 7
Port and Cable Specifications
FE Port
The FE port provides a 10/100 Mbps Ethernet connection to a network. The
RJ-45 female connector port pin-outs are shown below:
The port accepts a 4- or 8-conductor Category 5 UTP Ethernet cable with an
RJ-45 male connector. A straight-through cable is required for connection to a
network port. A crossover cable is required for connection to a management
workstation.
For cables that run through plenums or air-handling spaces as described in
NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article
800.50 and marked accordingly for use in plenums and air-handling spaces
with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP. Be
sure to install cables in accordance with all applicable local regulations and
practices.
10/100 Mbps Ethernet RJ-45 Female
Pin-Out
*POE optional
**Serial optional
Serial TxD** (POE positive*)
Serial TGND** (POE positive*)
Serial RxD** (POE negative*)
Serial RGND** (POE negative*)
1
2
3
4
5
6
7
8
ETH Rx+ (POE negative*)
ETH Rx– (POE negative*)
ETH Tx+ (POE positive*)
ETH Tx– (POE positive*)
Direction
Input
Output