Use and Care Manual

— 45 —— 44 —
SETTING UP THE Power Switch AS A REPEATER
v
While the LED is blinking blue
and orange, activate the pairing
mechanism on the End Sensor
(pressing the Pairing button, removing
the compartment, etc., see pages
23-24). The LED on the Power Switch
will then turn solid orange, indicating
the repeater pairing process has been
completed.
u
Make sure the Power Switch and
the Sensor you want to “extend the
range” have been successfully paired/
connected to the system Control Hub.
Press and hold the Power Switch
button until the LED begins blinking
blue and orange.
x
Press and hold the Power Switch
button and plug the switch back to
the outlet with the button pressed. Do
not let go of the button until the LED
begins to blink blue. Both the Power
Switch and the End Sensor will require
pairing with Control Hub again to
resume their normal operation.
w
To Deactivate the Repeater Mode:
Unplug the Repeater Power Switch.
Setup
Note: You will not be able to control
the End Sensor if the Power Switch
(repeater) is removed. Plug the Power
Switch back in to regain the control
and communication between control
hub and end Sensor.
Model AHS613 does not include a Power Switch.