Use and Care Manual

— 29 —— 28 —
INSTALLATION
Installing the Motion Detector
Installing the Siren
6 to 8 feet
50 feet
110 degrees detection angle
A
B
v
Flat Wall: Place the unit back onto the
back cover.
Corner: Hang on the corner bracket.
v
Place the unit back onto the bracket.
Option B - Screws (Corner
Bracket and Screws included)
u
Flat Wall: Remove back cover and
insert the four screws as shown (A).
Corner: Insert the two screws into the
corner bracket as shown (B).
u
Remove back cover and insert
the three screws as shown. It is
recommended to install the siren in a
highly visible location with minimum
obstacles nearby for maximum visual/
sound alert.
Notes:
• When it is finished, wave hand in front to see
if App activates.
• See page 17 for installing/replacing the
batteries.
• The Motion Detector is most effective in areas
such as hallways and entry points where
intruders may likely pass through.
• The Motion Detector monitors movements
up to 16 meters away, with 110 degrees
detection angle. Make sure it is angled facing
with the least obstructions for best coverage.
Notes:
• When it is finished, test to make sure it
sounds.
• See page 21 for installing/replacing the
batteries or connecting to AC Power.
Corner Braket is optional