Use and Care Manual

— 28 —
INSTALLATION
Installing the Door/Window Sensor
Installing the Motion Detector
6 to 8 feet
50 feet
110 degrees detection angle
A
B
6 to 8 feet
50 feet
110 degrees detection angle
A
B
A
B
C
v
Select a desired location. It is
recommended to place the Motion
Detector in the corner of the room
and between 6 to 8 feet from the
floor. See notes in step 2 of the
top of the next page for installation
recommendations.
v
Open the back cover of the small
section. Use the two mounting
screws to fix the back cover onto the
movable part of the door/window
frame (C - figure in step 1). Insert the
sensor onto the back cover.
Option A - Double-Sided Tape
u
Apply the double-sided tape to the
rear of the Motion Detector as shown.
Use the thick tape for flat wall mount
or the thin tape for corner mounting.
Option B - Screws (included)
u
Insert the first mounting screw
directly onto the door/window frame
(A). Hang the larger section on the
mounted screw, remove the battery
compartment cover and insert the
second screw (B).
Notes:
• When it is finished, open the door or window
to test if the sensor has been correctly
installed. You’ll receive an alert from the
mobile device if the App and sensor have
been correctly installed and paired.
• See page 15 for installing/replacing the
battery.