Manualshelf

Use and Care Manual

ManualsBrandsALC ManualsAir Compressors, Tools & Accessories36 in. x 24 in. Polymer Floor Model Cabinet, Foot Pedal with Starter Kit
12345678910
40391 Assembly Instructions
Page 6
ASSEMBLY INSTRUCTIONS
1. Install all four legs: there are two types of legs. One leg fits Left Front (LF) or Right Rear (RR). The
other leg fits Right Front (RF) or Left Rear (LR).
2. Take gloves and slip over circular flanges inside the cabinet. Secure gloves to flanges with glove
clamps. If cabinet is supplied with 18” rubber gloves, help may be required to stretch gloves over
the flanges. This is normal. If cabinet is supplied with 24” vinyl gloves, excess material at
gauntlet must be folded over before installing glove clamp.
3. Attach abrasive blast hose to pick-up tube on inner portion of pick-up tube leaving 1/4” gap
between hose end and outer tube. Lay pick-up tube in bottom of cabinet with hose end towards
right rear of cabinet. Attach other end of hose to suction head of gun.
4. Attach pressure inlet hose (not supplied) to 1/4” threaded inlet on gun. If using whip hose inside
cabinet, run threaded end through 9/16” diameter hole on lower right side of cabinet and attach
quick disconnect nipple to hose end and tighten. If using shop hose directly through inlet hole to
gun, the hold may need to be opened to accommodate hose diameter.
WARNING!
Disconnecting hose while Unit is under pressure could cause serious injury or death. Use
safety lock pins and safety cables in all coupling connections to help prevent hose couplings
from accidental disconnection.
If twist-on type air hose couplings are used, they must be secured by safety lock pins or wires
to prevent accidental disconnection while under pressure. Hose disconnection while under
pressure could cause serious injury.
OPERATING INSTRUCTIONS
1. Maximum operating pressure is 110 PSI. Air consumption with medium nozzle supplied with
cabinet is 15 CFM at 80 PSI.
2. To change abrasive, remove plug at bottom front of cabinet and drain into suitable container.
Reinstall plug and pour new abrasive into cabinet.
3. The plug in the right upper side of cabinet is for installation of a dust collector or shop vac. If you
choose not to use a dust collector, keep this hole plugged. We strongly recommend the use of a
dust collector or the cabinet will leak dust.
4. The 3” hole with louver vent in the upper left rear of the cabinet provides for proper venting of the
cabinet during use. Never plug.