Use and Care Manual

40390 Assembly Instructions
Page 11
MAINTENANCE
WARNING!
Failure to observe the following before performing any maintenance could cause serious
injury or death from the sudden release of compressed air:
 Depressurize the blast machine.
 Disconnect power supply.
 Lockout and tagout the compressed air supply.
 Bleed the air supply line to the blast gun.
Immediate replacement of worn components is required. Failure to replace worn components
could expose the operator or bystanders to high speed media and compressed air could
cause death or serious injury.
Leaks around couplings and nozzle holders indicate worn or loose fitting parts. Nozzle
holders and couplings that do not fit tightly on hose and nozzles that do not fit tightly in
nozzle holders could disconnect while under pressure. Impact from nozzles, couplings,
hoses, or abrasive, and parts disconnected while under pressure could cause severe injury.
Coal Slag #40093
Coal Slag is used when paint and rust has to be removed from steel, such as car bodies, tanks or
heavy machinery. Coal Slag is faster cutting, can be re-used, is moisture free, and will not pack or
absorb moisture. (25 Lb. container)
Steel Grit #40109
Steel grit is extremely fast cutting on rusty metal and hard to remove paint. Steel Grit is popular
because it leaves a very smooth finish. It is also comparable in price to most other specialty
abrasives. Steel Grit is recommended in reclaim systems or cabinets. (25 Lb. container)
Glass Bead #40105
Glass Bead is used in creating a satin or matte finish. Glass Bead is recommended in reclaim
systems or cabinets. (25 Lb. container)
Aluminum Oxide #40098
Aluminum Oxide is a high quality abrasive that is sharper than sand (not recommended) and cuts
twice as fast as sand. It leaves a smooth textured finish with no pits or burrs. Aluminum Oxide is
rougher than glass bead and can be used over and over again. It is one of the most economical
abrasives you can use in any reclaim systems or cabinets. (4/25 Lb. container)