Use and Care Manual

40001, 40003, 40004, 40005 Assembly Instructions
Page 7
NOZZLE SELECTION CHART
PART NO.
ALC
NOZZLE I.D.
CFM
PSI
BLASTING AREA
SQ. FT./MIN.
ABRASIVE
USAGE/HR.
40067
3/32”
7
80
1/2
100 lbs.
40068
1/8”
15
80
1 to 1-1/2
150 lbs.
40069
5/32”
25
80
2 to 2-1/2
200 lbs.
40070
3/16”
40
80
3 to 3-1/2
300 lbs.
40071
1/4”
80
80
4 to 4-1/2
500 lbs.
40072
5/16”
125
80
5 to 6
800 lbs.
NOTE: Blast area coverage per minute and abrasive consumption are
approximate guidelines. Abrasive material and surface blasted may alter coverage
and consumption rates. Furthermore, for each 50 feet of blast hose there will be a
5 PSI pressure drop.
WARNING!
The threads on the nozzle and nozzle holder must be inspected each time the nozzle is
secured to the holder. Check the threads for wear, and make sure nozzle holder securely
grips the nozzle. The nozzle washer must also be inspected for wear. Worn nozzle washers
cause thread erosion. A loose-fitting nozzle may eject from the holder under pressure and
could cause severe injury.