Operation Manual

Accept incoming calls and adjust receiving volume

• By once pressing the talk button at your Bluetooth

headset you can take over a call with your

wireless headset. Switch-over will always take a short moment. During switch-over you will hear a

short melody.

• Adjust the earphone volume by pressing the volume buttons or of the headset according to

your wishes. You may also feel the volume keys with your fingers: The key with one dot reduces the

volume, while the key with 2 dots will increase it. This adjustment will have no effect on the volume

of the microphone! This volume is automatically adjusted by the volume of our own voice and the

integrated DSP (digital signal processor).

• After finishing your call do not forget to put back your handheld receiver, otherwise the line might still

be occupied thus creating unnecessary costs!

Important advice for transmission range:

The Bluetooth™ headset has an averange range of about 10m. This range can be influenced by your

surroundings. Electronic appliances close to your telephone may reduce range whereas a free area may even

increase it.

In case your Bluetooth™ headset has lost connection to your telephone just press the center button

at your headset to reconnect. In case this does not work, just switch your headset off for a short moment and

on again before pressing the center button at your headset.

Pairing between Bluetooth

Headset and Audio-Gateway

According to the international Bluetooth

standards and agreements your headset ist able to establish a

reliable and safe audio transmission to a lot of different devices using the Bluetooth

technology.

Your headset comes factory programmed („paired“) and ready for use with the individual audio-gateway

supplied together as a set. If you want to connect the headset with other Bluetooth

devices (e.g. mobile

phone), or if you have already used your headset with another device, you must repeat the pairing procedure

before reconnection to your audio-gateway.

In such a pairing procedure, headset and partner device must exchange informations and security data,

before they can mutually acknowledge themselves as partner units. This procedure, which includes a reset, is

defined as „pairing“. Important: Only paired devices can communicate with each other, there is no

comminication possible with a third device at the same time. For pairing with other devices please read the

last chapter of this manual.