Specifications

52 English
Setup
Setting up the Scanner
Connect the Antenna
1. Align the slots around the antenna’s connector with the tabs on
the scanner’s BNC connector.
2. Slide the antenna’s connector down over the scanner’s connector.
3. Rotate the antenna connector’s outer ring clockwise until it locks
into place.
The scanner’s BNC connector makes it easy to connect a variety of
optional antennas, including an external mobile antenna or outdoor base
station antenna.
Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable to connect an
outdoor antenna. If the antenna is over 50 feet from the scanner, use
RG-8 low-loss dielectric coaxial cable. If it is less than 50 feet, use RG-
58. You can get a BNC adapter at local electronics stores.
Connect an Optional Earphone/Headphone
For private listening, you can plug a 1/8-inch (3.5 mm) mini- plug
earphone or stereo headphones (not supplied) into the headphone jack
on top of your scanner. This automatically disconnects the internal
speaker.