Owner`s manual

AE75H OWNER’S MANUAL

Follow the installation instructions supplied with the antenna, route the antenna cable to the scanner,

then connect it to the ANT jack.

Warning: Use extreme caution when installing or removing an outdoor base station antenna. If the

antenna starts to fall, let it go! It could contact overhead power lines, if the antenna touches a power

line, contact with the antenna, mast, cable or guy wires can cause electrocution and death! Call the

power company to remove the antenna. Do not attempt to do so yourself.

USING THE BELT CLIP

You can use the belt clip for hands-free carrying when you are on the go. Simply slide the belt clip over

your belt or waistband.

CONNECTING AN EARPHONE/HEADPHONES

For private listening, you can plug an earphone or mono headphones with a 3.5 mm plug into the

PHONE jack on top of your scanner. This disconnects the internal speaker.

Caution: To protect your hearing, follow these guidelines when you use an earphone or headphones:

• Do not listen at extremely high volume levels. Extended high-volume listening can lead to

permanent hearing loss.

• Once you set the volume, do not increase it. Over time, your ears adapt to the volume level, so a

volume level that does not cause discomfort might still damage your hearing.

Warning: Do not use an earphone or headphones with your scanner when operating a motor vehicle or

riding a bicycle, in or near traffic. Doing so can create a traffic hazard and could be illegal in some

areas.

CONNECTING AN EXTENSION SPEAKER

In a noisy area, an extension speaker or an amplified speaker might provide more comfortable listening.

Plug the speaker cable’s 3.5 mm plug into your scanner’s PHONE jack.

YOUR SCANNER

A LOOK AT THE KEYPAD

Your scanner’s keys might seem confusing at first but this information should help you understand each

key’s function.

SCAN – scans through the programmed channels.

MANUAL – stops scanning to let you directly enter a channel number.

BAND – selects a preprogrammed search band.

MON – accesses the monitor memory.

LICHT – turns on/off the display’s backlight

Up/Down-symbols -- searches down or up from the currently displayed frequency, or selects the

direction when you scan channels.

(key symbol) – locks/unlocks the keypad to prevent accidental entries.