Owner`s manual

AE75H OWNER’S MANUAL

RESETING/INITIALIZING THE SCANNER

If the scanner’s display locks up or does not work properly after you connect a power source, you might

need to reset or initialize it.

Important: If you have problems, first try to reset the scanner. If that does not work, you can initialize the

scanner, however, initializing clears all frequencies you stored in the scanner’s memory and initialilzes

the scanner to its default settings.

Resetting the Scanner

1. Turn off the scanner, then turn it on again.

2. Insert a pointed object, such as a straightened paper clip, into the reset hole on the side of the

scanner. Then gently press and release the reset button inside the opening. The display goes blank,

then information reappears.

Initializing the Scanner

Important: This procedure clears all frequencies you stored in the scanner’s memory and initializes the

scanner to its default settings. Initialize the scanner only when you are sure the scanner is not working

properly.

1. Turn off the scanner, then turn it on again.

2. While holding down CLEAR, insert a pointed object, such as a straightened paper clip, into the reset

hole on the side of the scanner. Then gently press and release the reset button inside the opening. The

display goes blank, then information reappears.

Note: You must release the reset button before you release CLEAR. Otherwise, the memory might not

clear.

3. When the display reappears, release CLEAR.

CARE AND MAINTENANCE

The following suggestions will help you care for your scanner so you can enjoy it for years.

Keep the scanner dry. If it gets wet, wipe it dry immediately.

Use only fresh batteries of the required size and type. Always remove old and weak batteries. They can

leak chemicals that destroy electronic circuits.

Handle the scanner gently and carefully. Dropping it can damage circuit boards and cases and can

cause the scanner to work improperly.

Use and store the scanner only in normal temperature environments. Temperature extremes can

shorten the life of electronic devices, damage batteries, and distort or melt plastic parts.

Keep the scanner away from dust and dirt, which can cause premature wear of parts.

Wipe the scanner with a damp cloth occasionally to keep it looking new. Do not use harsh chemicals,

cleaning solvents, or strong detergents to clean the scanner.