Operation Manual

34
Select Step Frequency
You can change the frequency steps (channel spacing). Selected step affects both
band search and Close Call. For air band selected step affects more air service bank.
If the scanner displays for 3 seconds while selecting step frequency mode the scanner
returns to Band Search.
1. Press
SEARCH
or
BAND/STEP
key to start Band
Search.
2. Press and hold
BAND/STEP
key until the scanner displays the current steps
and the confirmation tone is generated.
3. Use
or to select steps from Auto, 5kHz, 6.25kHz, 10kHz, 12.5kHz (When
Auto is selected, the scanner searches from 84.015 MHz to 87.295 MHz with 20
kHz spacing in the German 4 m Band).
4. Press
BAND/STEP
key to change the steps for air band, the scanner displays
the current step for air band.
5. Use
or to select steps for air band from 8.33kHz and 12.5kHz. And then
press
PROG
key to exit and then the scanner returns to Band Search.
Clock Mode
Your scanner’s Clock displays whenever you turn off the radio functions. The time
indicates 24 hours. When the scanner is in Clock Mode no beep is generated. After 3
seconds when turning off the scanner the backlight is turned off.
To set the current time:
1. Rotate
VOLUME/CLOCK
knob counterclockwise to turn off the AE355M unit.
2. Press and hold
PROG
to enter the clock setting mode. The Band Plan number
is displayed for 1 second and the backlight is turned on. Then the clock time will
flash.
3. Press
or to change the time. Press and hold or over 2 seconds to
step up or down 15 minutes steps repeatedly. To cancel the setting, press
BAND/STEP
.
4. Press
PROG
to store the current time. The scanner displays the clock. After 3
seconds the backlight is turned off.
After you press any key the scanner exits Clock Setting Mode 3 minutes later.