Specifications

23
One or more
channels
might be
locked out.
Make sure the channels you
want to scan are not
locked out.
The antenna
might need
to be
adjusted.
Check the antenna connection.
Resetting the Scanner
If the scanner's display locks up or stops operating properly,
you might need to reset the scanner.
Caution: This procedure clears all the information you have
stored in the scanner. Before you reset the scanner, try
turning it off and on to see if it begins working properly. Reset
the scanner only when you are sure it is not working properly.
After a reset, only the band plan information and the
preprogrammed search bands are still memorized in the
scanner!
To reset the scanner:
• Turn of the scanner.
• While holding down 2, 9, and Hold, turn on the
scanner. It takes about 3 seconds to initialize and
CLEAr appears.
Care and Maintenance
Keep the scanner dry. If it gets wet, wipe it dry immediately.
Use and store the scanner only in normal temperature
environments. Handle the scanner carefully: do not drop it.
Keep the scanner away from dust and dirt, and wipe it with a
damp cloth occasionally to keep it looking new.
General Use
• Turn the scanner off before disconnecting the power.
• Always write down the programmed frequencies in the
event of memory loss.
• If memory is lost, simply reprogram each channel. The
display shows 000.000 in all channels when there has
been a memory loss.
• Always press each button firmly until you hear the entry
tone for that key entry.
Locations, environment
• Do not use the scanner in high-moisture environments
such as in bathroom or outdoor if it is raining.
• Avoid placing the unit in direct sunlight or near heating
elements or vents.
• If the scanner receives strong interference or electrical
noise, move it or its antenna away from the source of the
noise. If possible, a higher elevation might provide better
reception.
• Also try changing the height or angle of the antenna.