Specifications

21
Call Options” starting on page 19 and interrupts the audio
when it checks for a Close Call transmission in that range.
Notes:
• Set the squelch tight (where only strong signals are
received) while using Close Call.
• To continue scanning normally while the Close Call
feature is working, simply press Scan twice.
• When the scanner finds a frequency, it sounds the
alert you specified in “Setting the Close Call
Options” on page 19, and Found flashes.
• Press any key to confirm the displayed frequency.
Press Scan to resume scanning.
• To change the band, press Hold to stop searching,
then press Func. You can select the band using ^ or
v.
F
To turn on the Close Call feature and turn off normal scanning,
press (Func + ) twice. flashes.
To turn off Close Call and turn on normal scanning, press
(Func + ) three times. disappears.
F
Close Call Skip Memory
You can skip Close call frequencies so that you can avoid
unwanted frequencies or those already stored in a channel.
See page 25 for further explanation of Skip Memory.
Close Call Delay
You can program a 10-second delay while using Close Call.
With this feature, the scanner continues to monitor the
frequency for additional 10 seconds after the transmission
stops before resuming scanning or searching. The scanner
automatically sets a delay when you store frequencies into
channels or when you search frequencies.
To program the Close Call Delay, press DLY during Close Call
mode.
To cancel Close Call Delay, press DLY during Close Call mode
again.