Specifications

without removing the sticker, or, after removing, make sure that

the battery switch is correctly set to NI-MH BATT..

Only in this position the adapter can power the scanner and

recharges the installed batteries at the same time.

Connecting the Antenna

To attach the supplied flexible antenna to the connector on the

top of your scanner, align the slots around the antenna's

connector with the tabs on the scanner's BNC connector. Then

slide the antenna's connector down over the scanner's

connector and rotate the antenna connector's outer ring

clockwise until it locks into place.

Connecting an Optional Antenna

The scanner's BNC connector makes it easy to connect a

variety of optional antennas, including an external mobile

antenna or outdoor base station antenna.

Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable to

connect an outdoor antenna. If the antenna is over 15 m from

the scanner, use RG-213/U or “air cell” type low loss coaxial

cable. You can get a BNC adapter at your local electronics

store.

Connecting an Earphone/ ext. Speaker

For private listening, you can plug a 3.5 mm mini plug earphone

or mono or stereo headphones (not supplied) into the

headphone jack on top of your scanner. This automatically

disconnects the internal speaker.

Connecting an Extension Speaker

In a noisy area, an optional extension speaker, positioned in the