Specifications

10
Using Internal Batteries
You can power your scanner using the supplied rechargeable
NiMH batteries ( 2 x AA).
Using Rechargeable Batteries
Before you use NiMH or NiCd batteries the first time, you must
charge them. It may happen, that the first battery charging may
not reach the full capacity, but the final capacity will be ok after at
least 2-3 times charging.
The scanner has a built-in circuit that lets you recharge NiMH or
NiCd batteries while they are in the scanner.
To charge the batteries;
1. Make sure the power is turned off.
2. Slide the battery compartment cover.
3. Install two batteries in the compartment as indicated by the
polarity symbols (+ and -) marked inside.
4. Replace the cover.
5. Connect the supplied AC adapter to the scanner’s DC 6 V
The switch is factory preset to
NiMH battery and covered by a
sticker. Remove the sticker if You
want to use alkaline batteries