Specifications

34
Cloning the Scanner
To clone (copy) data from one AE230H scanner to another
AE230H scanner, you must first connect the scanners to
each other using the included connection cables and a 9 pin
SUB D null
modem adapter
cable + 9 pin
gender changer
adapter (neither
included), available at most computer stores. Depending on
the computer supplier, also combined gender changers with
null modem function are available, so that You may need
only one common adapter.
It is also possible to solder 2 male plugs 9 pin SUB D
together according to following scheme:
Then you must set one scanner as the master (source) and
the other as the slave (destination).
Plug the smaller end of each of the included connection
cables into Remote on the right side of each scanner. Then
connect the other end of the cables together using the null
modem connector and gender changer.
Then set up both scanners.
XFER INFORMATION E
WIRED CLONE E
• MASTER This will be the master (source) scanner.
• SLAVE This will be the slave (destination) scanner.
(Master scanner) E
CLONE MASTER PRESS SCAN KEY
(Slave scanner) E
Plug 1 Plug 2
1 4
2 2
3 3
4 6 & 1
5 5
6 4
7 8
8 7
9 frei 9 frei