Specifications

9
Before the
AE 77 H can receive
radio broadcasts, you must program a
frequency into at least one channel.
Before scanning, repeat this procedure
for each channel you program.
1. Press .
2. Select a channel.
a) Enter the channel number.
b) Then press /PROG.
3. Enter the frequency.
a) Enter the frequency number.
b) Then press .
Note: To clear a mistake while
entering the frequency, press
/MON/CLR twice, and
start over.
STEP
Programming
If the frequency entered is outside the
frequency range of the scanner, a
distinctive beep sounds. (See the table
on page 6 or the band list on page 19.)
Press /MON/ CLR and go back
to Step 3.
Programming Tips
• Group similar frequencies into
adjacent channels. For example,
program Marine frequencies in
channels 1 through 10 and public
services into channels 11 through 20
and so on.
• Put the frequency that you listen to
the most or the most important
frequency into a priority channel.
• To quickly program a series of
channels, start with the lowest
number channel. For example, when
you are programming five new
frequencies into channels 4 through
8, start with channel 4. After you
finish programming a channel, press
/PROG to go to the next
higher channel.
• To erase the channel, press ,
and then press . Channels
with no frequencies are
automatically locked out.
• Record channels and frequencies in
some convenient place in case the
scanner memory is lost.
STEP
UB01294AZ_1 2/3/04 1:27 PM Page 9