Specifications

13
2. Enter lower limit of the search band.
a) Enter the frequency number.
b) Then press .
c) Then press /LIMIT.
BAND
Searching
Band Search
The AE 77H has 6 factory-
Preprogrammed Search Bands. You
can search any of these Bands to find
desired frequencies if you do not have
a Frequency Directory handy, or if new
stations have been added since the
Directory was published.
1. Press and hold /LIMIT to
enter the Band Search Mode. Then
the upper and lower limits of the
band currently selected are
displayed.
2. Press ▲ or ▼ to select the band you
wish to search.
3. Wait for about 2 seconds and the
UBC105XLT will begin searching
that Band. Or, press /LIMIT
again to begin.
4. Press /LIMIT at any time to
stop the search on a frequency.
Press /LIMIT to resume
searching.
BAND
BAND
BAND
BAND
Limit Search
In Limit Search mode, you can search
within the frequency range you have set.
To use this function, you must set the
lower/higher frequency of your search
range list.
To program a frequency range follow
these steps:
1. Press /PROG to until the
search channel you want appears in
the display, and press /LIMIT.
BAND
STEP
5. When Search is stopped, you can
press ▲ or ▼ to move up or down 1
frequency step. (See the table on page
19 for the step size for each Band.)
UB01294AZ_1 2/3/04 1:27 PM Page 13