Operating instructions

BDA_S30_GB_final_Pfade.fh11 07.12.2009 11:57 Uhr Seite 16
Probedruck
C M Y CM MY CY CMY K
16
2.6.3
Driving program selection switch [26]
When it is delivered to you, the scalamobil is individually
set to meet your requirements by an
representative.
Amongst other things, parameters such as the height of the
steps on the staircase that you use is permanently stored
as “Home staircase mode”.
If you travel up or down a staircase other than the one
stored in the device, then you can temporarily deactivate
the programmed setting by pressing the driving program
selection switch [26]. The scalamobil will then operate
using the factory setting or “Other staircase mode”.
If you then wish to revert to the preset staircase, place the
driving program selection switch [26] back to the “Home
staircase mode” setting.
For further details on these modes of operation, please
contact your
representative.
Switch pressed in: Home staircase mode activated
Switch not pressed in: Other staircase mode activated
2.6.2
Rotation Regulator [13]
With the rotation regulator you can adjust the climbing
speed to your liking. The lowest speed is 6 steps per minute
at position 1 of the switch; the highest speed comes to 19
steps per minute at position 6.
New users should avoid the highest speed when
they first learn how to operate the scalamobil
until they are used to handle the device safely.
·For the first driving exercises, the maximum speed
is to be reduced.
·Make yourself familiar with the driving behavior of
the electric system and slowly determine your limits.