User`s manual

6
2
Wheels
2.1
Mounting the Wheels
The two electrically powered wheels are the heart of the
e·fix. The wheelchair's standard manual wheels are exchanged
with the e·fix wheels as follows. Please lift the wheelchair
somewhat.
· Remove the wheelchair's left wheel according to the
wheelchair's user's manual.
· Take an e·fix wheel and turn the coupling plate [15]
counter clockwise to position "I."
· Press the middle of the shutter [17] with your thumb so
that the inserted bow-type handle [16] pops out.
· Pull out the bow-type handle all the way.
· Insert the stub axle [21] of the e·fix wheel approximately
halfway into the wheel receiver [24]. In this position the
bow-type [16] handle juts out about 5mm above the
shutter [17].
· Turn the e·fix wheel until the torque plug [22] on the
wheel and the torque socket [23] on the holding device
on the wheelchair are vis-à-vis each other.
15
17
21
16 16
· Now insert the e·fix wheel all the way into the wheel
receiver [24]. Also make sure that the torque plug [22]
on the wheel is inserted into the torque socket [23] on
the holding device at the same time.
· Check whether the wheel is locked into place by pulling
on it. If the bow-type handle [16] folds all the way into
the shutter [17], the wheel is locked properly.