User manual

4.4.3 Adjusting dial switch for selecting speed

Select the maximum speed (stepless), that the e-ﬁx is required to reach when the joystick

is fully moved, by turning the dial switch [23]. The adjustment range is between

1.5 km/h and 6 km/h. The set value (maximum 99) is indicated as a percentage via a

2-digit display.

Wheelchair drivers who use the e-ﬁx for the ﬁrst time, should begin at a low speed

(see also Chapter 6.2).

4.4.4 Horn

In order to signalize a dangerous situation, the horn can be activated via the button [24].

· If the button [24] is pressed, a permanent acoustic signal can be heard.

4.4.5 Menu button

To protect the e-ﬁx from misuse by unauthorized persons, an immobilizer can be

activated. Press the menu button [25] (approx. 3 sec.) until the display goes off. The

e-ﬁx switches off automatically.

If the e-ﬁx is switched on with activated immobilizer, the lock symbol in the control unit

display ﬂashes.

Press the menu button again [25] for approx. 3 seconds. The lock symbol then goes off

and the e-ﬁx is ready for driving.

The immobilizer is not intended as a protection against theft as the drive wheels

can be disengaged and the wheelchair can be pushed away.

4.4.6 Drive parameters

Various drive parameters are stored in the e-ﬁx software. Your dealer can set these

parameters to suit your speciﬁc requirements.

The standard functions are as follows:

Function

Max. speed forwards

Max. speed backwards

Acceleration time

Deceleration time

Rotation speed

Rotational acceleration/deceleration

Buzzer

Brake

Automatic shut-off time

Joystick throw

Exchange axle of joystick

Setting

100 % = 6 km/h

60% of the max. speed = 3.6 km/h

1.5 sec

28 % of the max. speed

0.31 sec

Active

Time delayed by 30 seconds

1 hour

100 %

BDA_E25_innen_GB_USA_final.indd 12 10.07.2008 12:06:58 Uhr