User manual

15.2. Removal / Reassembly of the Front Castor Wheel

(photo 40)

• Remove the electric drive unit from the frame.

• Place the frame on a clean surface with the push handles

backwards.

• Loosen nut (A) with a 5 mm Allen wrench while holding screw

(B) with a second 5 mm Allen wrench.

• Remove screw (B) from the fork.

• Remove the wheel from below.

To reassemble front wheel proceed in the reverse order.

15.3. Replacing the Tyre / Inner tube (gure 41)

• Unscrew the valve cap (A).

• Let out the air from the inner tube (B) by pushing on the spring

pin.

• With the help of a tyre remover, free the tyre (C) from the rim,

starting on the valve side.

• Remove the inner tube from the tyre.

Replacing the tyre

• With the help of a tyre remover, free the opposite side of the

tyre from the rim.

• With the help of a tyre remover, lift the rst side of the tyre (C)

above the rim

Assembling/replacing the inner tube (photo 41)

• Place the inner tube (B) inside the tyre and inate it slightly.

• Ensure that inner tube (B) and valve (A) are correctly positioned.

• Put the opposite side of the tyre (C) on the rim, starting from

the side opposite valve (A).

• Ensure that the inner tube (B) isn’t caught between the rim and

the tyre (C).

• Inate the inner tube to the recommended pressure written on

the tyre (usually 2.5 bars).

• Ensure that the tyre (C) is correctly placed on the rim.

16. Nameplates

The wheelchair nameplates provide important technical

information; they make chair identication easier and help with the

ordering of replacement parts.

e-x

They are found on the inner side of the 2 motorised wheels and

on the battery pack connection interface.

Scalamobil:

They are located on the rear side of the motor-battery unit

The serial numbers are stuck to the folding cross-brace as well as

on the interface.