User manual

4.1.6. Comfort Dartex seat

- Comfort Dartex seat (photo 14):

It is removable for folding the wheelchair; just lift up the seat and

put it aside, then hold the 2 chair rails and pull upwards.

Do the reverse for unfolding (see § 2.1.1).

The cover and padding of this seat is subject to wear, contact

your Distributor for any replacement.

Take care that the seat is well positioned on the 3 Velcro seat

strips to ensure the safety and comfort of the user. In order to

avoid any injury when folding and unfolding, keep your ngers away

from any moving parts!

- Comfort Dartex backrest (photos 15 & 15A):

Consisting of a rigid shell (A) and a preformed foam cushion (B)

afxed with Velcro, it ensures an optimal comfort. It is removable

for folding the chair: release the two buttons (C), slide the triggers

(D) inwards and release the hooks (E) from their supports. Do the

reverse to put it back in place.

• To adjust the width, slightly loosen the screw (B) and slide the

armrest to the desired width. Firmly tighten up the screw (B).

• There are two available positions for the depth according to body

shape or comfort desired by the user (positions C or D).

NOTE: the lateral protection adjustment may be necessary

according to the height chosen, unscrew the four xation screws

(E) and replace them in the new position, rmly tighten up the four

screws (E)

These armrests are xed on an adjustable carrier (in 2 parts)

which allows you to reduce the looseness and facilitates removal

during transfers, the 4 screws should be tightened or loosened (F)

according to the desired result

The armrests are xed by pair on the chair, when dismantling;

remember that there is a left side and a right side!

Never lift the chair by the armrests! In order to avoid any

injury during folding, dismantling or adjusting operations, keep your

ngers away from any moving parts!

C&D

15A