User`s manual

Creating a Security Array With An Existing Data Drive

NOTE: MBFastTrak133 Lite permits only two drives to be used for a single Mirrored array in Auto Setup.

You would use this method if you wish to use a drive that already contains data and/or is the bootable

system drive in your system. You will need another drive of identical or larger storage capacity.

WARNING: Backup any necessary data before proceeding. Failure to follow this accepted

PC practice could result in data loss. If you wish to include your current bootable drive using

the Windows NT 4.x or Windows 2000 operating system as part of a bootable Mirrored

(RAID 1) array on your MBFastTrak133 Lite, do NOT connect the hard drive to the

MBFastTrak133 Lite controller yet. You MUST install the Windows NT4 or 2000 driver

software first (see page 15) to this drive while it is still attached to your existing hard drive

controller. For all other Operating Systems, proceed here.

Follow these steps:

1. Using the Spacebar, choose “Security” under the Optimize Array for section.

2. Press <Ctrl-Y> keys to Save your selection. The window below will appear.

Do you want the disk image to be duplicated to another? (Yes/No)

Y - Create and Duplicate

N - Create Only

3. Press “Y” for the Create and Duplicate option. The window below will appear asking you to select the

Source drive to use. FastBuild will copy all data from the Source drive to the Target drive.

Source Disk

Channel:ID Drive Model Capacity (MB)

Target Disk

Channel:ID Drive Model Capacity (MB)

[Please Select A Source Disk]

Channel:ID Drive Model Capacity (MB)

1 :Master QUANTUMCR8.4A 8063

2 :Master QUANTUMCR8.4A 8063

[↑] Up [↓] [ESC] Exit [Ctrl-Y] Save

4. Use the arrow keys to choose which drive contains the existing data to be copied.

5. Press [Ctrl-Y] keys to Save selection and start duplication. The following progress screen will appear.

Start to duplicate the image . . .

Do you want to continue? (Yes/No)

Y – Continue N – Abort

6. Select “Y” to continue. If you choose “N”, you will be returned to step 1.

7. Once complete, the following screen will appear confirming that your Security array has been created.

Press any key to reboot the system

Array has been created.

8. Proceed to the

Installing Driver

chapter on page 15 to install the MBFastTrak133 Lite driver

and/or operating system.