User`s manual

52
When this option is set to On, any event occurring at a
COM(serial)/LPT (printer) port will awaken a system which has
been powered down.
The Choices: LPT/COM (default), COM, LPT, NONE.
HDD & FDD
When set to On, any event occurring on a hard drive or a floppy
drive will awaken a system which has been powered down.
The Choices: ON (default), OFF.
PCI Master
When set to On, you need a LAN add-on card which supports
the power function. It should also support the wake-up on LAN
jumper.
The Choices: OFF (default), ON.
LAN Wake Up
To use this function, you need a LAN add-on card which support
power on function. It should also support the wake-up on LAN
jumper.
The Choices:
Disabled (default) Wake up on LAN not supported.
Enabled Wake up on LAN supported.
PCI PME Wake Up
When you select Enabled, a PME signal from PCI card returns
the system to Full ON state.
The Choices: Disabled (default), Enabled.
RTC Wake Up
When “Enabled”, you can set the date and time at which the
RTC (real-time clock) alarm awakens the system from Suspend
mode.
The Choices: Enabled, Disabled (default).
Date (of Month)
You can choose which month the system will boot up. This field
is only configurable when “RTC Resume” is set to “Enabled”.
Resume Time (hh: mm: ss)