User`s manual

37
AGP & P2P Bridge Control
If you highlight the literal “Press Enter” next to the “AGP & P2P
Bridge Control” label and then press the enter key, it will take
you a submenu with the following options:
AGP Aperture Size
Select the size of the Accelerated Graphics Port (AGP) aperture.
The aperture is a portion of the PCI memory address range
dedicated for graphics memory address space. Host cycles that
hit the aperture range are forwarded to the AGP without any
translation.
The Choices: 64M (default), 256M, 128M, 32M, 16M, 8M, 4M.
AGP Mode
This item allows you to select the AGP Mode.
The Choices: 2X, 4X (default), 1X.
AGP Driving Control
By choosing “Auto” the system BIOS will the AGP output Buffer
Drive strength P Ctrl by AGP Card. By choosing “Manual”, it
allows user to set AGP output Buffer Drive strength P Ctrl by
manual.
The Choices: Auto (default), Manual.
AGP Driving Value
While AGP driving control item set to “Manual”, it allows user to
set AGP driving.
The Choices: DA (default).
AGP Fast Write
The Choices: Disabled (default), Enabled.
AGP Master 1 WS Write
When Enabled, writes to the AGP (Accelerated Graphics Port)
are executed with one wait states.
The Choices: Disabled (default), Enabled.
AGP Master 1 WS Read
When Enabled, read to the AGP (Accelerated Graphics Port) are
executed with one wait states.