User`s manual

18
4.13 Floppy Disk Connector: FDC
The motherboard provides a standard floppy disk connector
(FDC) that supports 360K, 1.2M, 1.44M and 2.88M floppy disk
types. This connector supports the provided floppy drive ribbon
cables.
4.14 Hard Disk Connectors: IDE1/IDE2
This motherboard has a 32-bit Enhanced PCI IDE Controller that
provides PIO Mode 0~4, Bus Master, and Ultra DMA / 33, Ultra
DMA / 66, Ultra DMA / 100, Ultra DMA / 133 functionality. It
has two HDD connectors IDE1 (primary) and IDE2 (secondary).
IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1
can connect a Master and a Slave drive. You must configure the
second hard drive on IDE1 to Slave mode by setting the jumper
accordingly.
IDE2 (Secondary IDE Connector)
The IDE2 controller can also support a Master and a Slave drive.
The configuration is similar to IDE1. The second drive on this
controller must be set to slave mode.