Owner`s manual

ASSEMBLE ON FLOOR (continued…) ASSEMBLE ON WALL (continued…)

8. Align the base of each side column with the mark-

ings place on the floor earlier and bring the columns

into plumb.

9. Mark the locations of the mounting holes (4 per side

column). Prepare the holes and anchor as needed.

10. Loosely install the anchors, recheck for plumb, and

tighten the anchors.

6. Position the head assembly over the side columns

with the mounting brackets in line with the side col-

umns and carefully lower it into place.

7. Install the three 1/2” flat washers, lock washers, and

1/2”x1” bolts on each side of the head assembly to

secure it in place.

continue on to step 11 on the following page...

- INDICATES LOCATION OF FRONT COLUMN MOUNTING BOLT

8” long temporary

counterweight

retainer bolt.