Owner`s manual

15
Fasten the 8-32 nut to bolt to secure hose clamp to ’Z’ bracket.
T-handle must be in the fully retracted position during
the install and mounting process.
Verify the brake release arm is in the ‘Disengaged’ or upper
position.
Install cable clamp to the exposed end of brake release cable
and tighten the two nuts to secure clamp.
The T-handle mounting bracket can now be wall mount to desired height. Once mounted you will need to verify the
functionality of the brake release cable along with the functioning of the manual hoist. If the release rod is working
properly the hoist should require little effort to operate. Improper adjustment of the brake release will allow the brake
to drag during the hoisting of the door.
It is imperative that you verify the electrical interlock function of the hoist. When the hoist is engaged (red handle pulled
down) the hoist disengagement switch will open and if properly connected to the control will act as a stop input function
disabling the control from operating the door electrically. The control system should not be able to electrically function
the door while the hoist is engaged. Refer to the schematics supplied with the door for hoist interlock switch wiring.