Owner`s manual

14
Installing Manual Hoist Brake Release—Optional equipment
Doors equipped with a manual chain hoist will require the installation of a mechanical brake release rod that when
actuated will pull down on the manual brake release rod of the motor so that hoisting the door can be performed
without having to drive thru the brake of the motor.
Install the ‘Z’ bracket to chain hoist housing.
Use the nut and bolt to secure bracket to
housing.
Locate the brake release cable, hose clamp,
one 8-32x1/2” bolt and 8-32 Nyloc nut.
Install hose clamp to brake release cable. Place
hose clamp approximately 30mm away from
end of cable sheath.
Install 8-32x1/2” bolt into the hose clamp
Place exposed end of brake release cable through the
thru-hole on brake release arm.
Install brake release cable assembly to the ‘Z’ bracket.