Owner`s manual

350016-0000 26 Version 4/22/2010
RAPID ROLL
®
MODEL 355
INSTALLATION CHECKLIST
Door Serial No. __________
Date of Installation __________
Installer’s Name _________________________ Enduser__________________________
Company _______________________________ ________________________________
City ___________________ State ________ City _________ State ____ Zip_______
Phone No. ______________
MECHANICAL:
 Crate fully unpacked. Verified door parts against packing list. No parts are missing and
they are undamaged.
 Drive unit assembled to top roll assembly.
 Door top roll assembly attached to side frames.
 Side frames are plumb and door top roll assembly is level.
 Door secured to wall along side frames.
 Counter balance spring properly tensioned.
 Door does not bind in any position and has free movement over the entire range of
motion.
 Photocells mounted on inside back profiles. (Factory Wired)
ELECTRICAL:
 Fused disconnect installed and properly wired to control panel.
 Three phase power available at control panel.
 Control panel mounted at a serviceable height.
 Drive unit, door limit switches, gearbox disconnect switch, and brake motor kill switch
properly wired to control panel.
 Door actuators installed and properly wired to control panel (i.e. pushbuttons, pull
switches, floor loops, etc.).
 Proper phase rotation verified.
 Door limits properly set.
 Gearbox breather plug installed.
 All actuators tested and function properly.
 Door has been cycled at least 10 times to verify proper operation.
Notes:___________________________________________________________
________________________________________________________________
________________________________________________________________
________________________________________________________________
FAX COMPLETED FORM TO ALBANY INTERNATIONAL SERVICE DEPARTMENT AT [phone].