System information

Update when one or more configuration items are not supported in a BCU, CSU, or MSU

single configuration or a BCU, CSU, or MSU redundant configuration

***

19) Execute the ppupdate k.img active command. Installation from the internal flash

memory on the active system starts. The version of the basic software to be installed is

displayed. Make sure that the version is correct. After the update of the active system is

complete, the active system restarts automatically. In a BCU, CSU, or MSU redundant

configuration, a system switchover occurs. After the restart, log in to the Switch again.

Example

# ppupdate k.img active (Installation starts.)

Software update start

Broadcast Message from operator@

(??) at 22:38 UTC...

***********************************************

** UPDATE IS STARTED. **

***********************************************

Current version is 10.2

New version is 10.2.A (The version of the software is displayed.)

Automatic reboot process will be run after installation process.

Do you wish to continue? (y/n) y (Enter y.)

100% |*************************************| 21009 KB 502.42 KB/s 00:00 ETA

Update done.

Broadcast Message from operator@

(??) at 22:39 UTC...

***********************************************

** UPDATE IS FINISHED SUCCESSFULLY. **

***********************************************

# (Update is complete.)

ROM 00.11.26 (The active system restarts. System switching occurs in a BCU, CSU, or MSU redundant

configuration.)

...............

BOOT 00.11.00

current version=ROM 00.11.26(26)

new version =ROM 00.11.26(26)

Not changed.

Loading from dev0 100%