System information

3.5 Update procedure
The update procedure updates an older version of the software to a newer version.
To update the software:
1) Log in to the Switch, using the user-defined ID (for example, operator).
After logging in, if the command prompt is BOOT-INST-OS>, then the startup OS is
running. In this case, perform an installation according to the procedure described in 2
Software installation from the startup OS.
2) Enter the enable command. The command prompt changes to #.
Example
:
login: operator (Log in as operator.)
Copyright (c) 20XX ALAXALA Networks Corporation. All rights reserved.
> enable (Execute the en
able command.)
# (The command prompt changes to #.)
3) Execute the show system command. Confirm that the free capacity of the user area in the
internal flash memory of both BCU 1 and BCU 2 for an AX6700S series switch, CSU 1 and
CSU 2 for an AX6600S series switch, or MSU 1 and MSU 2 for an AX6300S series switch is
larger than the update file by 1,000 KB or more.
Example
# show system
Date 20XX/09/19 22:32:13 UTC
System: AX6304S, OS-SE Ver. 10.2
:
:
MSU1 : active
:
:
Flash
user area config area dump area area total
used 21,135kB 15kB 0kB 21,150kB
free 72,146kB 19,029kB 20,678kB 111,853kB
(Check the free capacity of the user area.)
total 93,281kB 19,044kB 20,678kB 133,003kB
MC : notconnect
MSU2 : standby
:
:
Flash
user area config area dump area area total
used 21,123kB 15kB 0kB 21,138kB
free 72,158kB 19,029kB 20,678kB 111,865kB
(Check the free capacity of the user area.)
total 93,281kB 19,044kB 20,678kB 133,003kB
MC : notconnect
:
:
#
17