System information

**
* Installation on the standby system ***
In a BCU, CSU, or MSU single configuration, go to step 8).
7) Execute the ppupdate k.img standby command. Installation from the internal flash
memory in the standby system starts. The version of the basic software to be installed is
displayed. Make sure that the version is correct.
Example
BOOT-INST-OS# ppupdate k.img standby (Installation starts.)
Software update start
Current version is 1.0
New version is 10.2 (The version of the software is displayed.)
Update done.
BOOT-INST-OS# (Installation is complete.)
*** Installation on the active system ***
8) Execute the ppupdate k.img active command.
Installation from the internal flash memory in the active system starts. The version of the
basic software to be installed is displayed. Make sure that the version is correct.
Example
BOOT-INST-OS# ppupdate k.img active (Installation starts.)
Software update start
Broadcast Message from operator@BOOT-INST-OS
(??) at 22:29 UTC...
***********************************************
** UPDATE IS STARTED. **
***********************************************
Current version is 1.0
New version is 10.2 (The version of the software is
displayed.)
100% |*************************************| 20999 KB 508.17 KB/s 00:00 ETA
Update done.
Broadcast Message from operator@BOOT-INST-OS
(??) at 22:30 UTC...
***********************************************
** UPDATE IS FINISHED SUCCESSFULLY. **
***********************************************
BOOT-INST-OS# (Installation is complete.)
11