Instruction manual

ManualsBrandsAlaxala ManualsComputer equipmentAX6700S series

1. Components Overview

Name Type Status Description

LINK

LED: Green or

Orange

Green: A link is established.

Orange: A failure has been detected.

Off: A link failure occurred

#3 #4

operation has stopped.

#3 #5

T/R LED: Green

Indicates the

operating status of

the Ethernet

port.

Blinking green: A frame is being sent

or received.

Off: No frames are being sent or

received.

#1: A network interface unit can be turned off by the Inactivate operation from the

system operation panel or by entering a command from the operation terminal.

#2: If no system recovery is set, the network interface unit is turned off in the

following situations:

z When a failure occurred in the network interface unit (the STATUS LED turns

red, and then it turns off).

z When a failure occurred in a basic control unit (when the basic control unit is

not duplicated).

#3: When the STATUS LED is green.

#4: Cable disconnection is also included.

#5: Operation of an Ethernet port can be stopped by entering a command from the

operation terminal.

#6: Always turns off if the interface port LED is set to off. When an operation key on

the system operation panel is used, the LED lights up, and the operating status can

be checked. If no keys are used for 60 seconds, the LED turns off again.

NOTE

If no system recovery is set and a failure occurs in a Switch, the

Switch can stay stopped without recovering the failed part.

(5) NK10G-8RX

The NK10G-8RX is a network interface unit with the following hardware

specification:

z Ethernet port (10GBASE-R): 8 ports

NOTE

For information about the XFP transceivers supported by the Switch,

see

1.8.2 XFP.

 Front view

The front view is shown below.

For information about LEDs, see Table 1-15 LED indications.