Instruction manual

5. Adding and Replacing Optional Modules
141
1. Match the software version with the version used in the active system (use
the ppupdate command).
2. Synchronize the configuration, user account, password, license key, and
other settings with the settings used in the active system (use the
synchronize command).
3. When an optional license has been installed, restart the basic control unit of
the standby system in order to reflect the license key information (use the
reload command).
6-2 Restore the operation information of the basic control unit (when only one unit
has been replaced in a non-dual configuration).
1. Restore the operation information from the file you have backed up (use the
restore command). To do this, use the backup file stored on a memory card
or an FTP server.
6-3 Restore the operation information of the basic control unit (when both units in a
dual configuration have been replaced).
1. Turn off the basic control unit in the standby system so that the system is not
switched during restoration of the operation information (execute the
Inactivate operation).
2. Restore the operation information from the file you have backed up (use the
restore command). To do this, use the backup file stored on a memory card
or an FTP server.
3. Turn on the basic control unit in the standby system (execute the
Activate
operation).
4. Match the software version used in the standby system with the version used
in the active system (use the
ppupdate command).
5. Synchronize the configuration, user account, password, and license key
settings of the standby system with the settings of the active system (use the
synchronize command).
6. When an optional license has been installed, restart the basic control unit of
the standby system in order to reflect the license key information (use the
reload command).
NOTE
For details about the Activate and Inactivate operations, see 11 Switch
Management in the Software Manual Configuration Guide Vol. 1.
NOTE
For details about the commands to use, see the following manuals:
restore command: 9. Checking the Software Version and Switch
Status in the Software Manual Operation Command Reference Vol. 1
ppupdate command: 13. Software Update in the Software Manual
Operation Command Reference Vol. 1
synchronize command: 29. Making Devices Redundant in the
Software Manual Operation Command Reference Vol. 1
reload command: 9. Checking the Software Version and Switch
Status in the Software Manual Operation Command Reference Vol. 1