Instruction manual

3. Preparation of Interface Cables and Terminals
71
Port Transceiver Interface Cable Connector
SFP-BX4D
1000BASE-BX4
0-D
Multimode fiber optic cable
(core/cladding diameter = 50
μm/125 μm)
XFP-SR 10GBASE-SR
Multimode fiber optic cable
(core/cladding diameter = 62.5
μm/125 μm)
XFP-LR 10GBASE-LR
XFP-ER 10GBASE-ER
10GBASE-R
port
XFP-ZR 10GBASE-ZR
Single-mode fiber optic cable
(core/cladding diameter = 10
μm/125 μm)
LC duplex
connector
AUX port -- RS-232C
RS-232C straight-through
cable
D-SUB 9-pin
connector
CONSOLE
port
-- RS-232C RS-232C crossover cable
D-SUB 9-pin
connector
10BASE-T
UTP cable (Category 3 or
higher)
MANAGEMEN
T port
--
100BASE-TX
UTP cable (Category 5 or
higher)
RJ-45
connector
#1: Some kinds of multimode fiber optic might increase the BER (bit error rate)
when used with 1000BASE-LX. In this case, proper communication can be
established by using the mode-conditioning patch code.
NOTE
For details about the interface cables to be connected to the
10/100/1000BASE-T port, 1000BASE-X port, or 10GBASE-R port, see
3.2 Details about interface cables.
NOTE
For details about the terminals and interface cables to be connected to
the AUX port, the CONSOLE port, and the MANAGEMENT port, see
3.3 Terminals and connection cables.