Instruction manual

5. Adding and Replacing Optional Modules
173
Figure 5-37 Installing a network interface unit (4)
(1) Screws
NOTE
Use a screwdriver to tighten the screws. Make sure the screws are
firmly tightened.
NOTE
If you install a network interface unit (NIF) while the Switch is on, the
NIF is turned on automatically when the NIF is installed.
Note, however, that if no power enable is set in the configuration, the
NIF is not turned on automatically. Set power enable, and then turn on
the power.
For details about the power enable command, see 12. Management
of BSU/NIF in the Software Manual Configuration Guide Vol. 1.