Instruction manual

MA-2 AX66S-H001X
4
Safety Information
The following note has been added after "Avoid looking directly at laser beams.".
Addition:
Do not touch the SFP-T transceiver during operation or just after operation has stopped.
During operation and when a link is being established, the temperature of the SFP-T transceiver can
rise to 65
o
C. Do not touch the SFP-T transceiver while it is operating and just after it has stopped.
Doing so could result in burns.
When you remove the SFP-T transceiver, use the procedure below. Failure to do so could result in
burns.
- To remove the SFP-T transceiver while the Switch is on, execute the inactive command, and
then wait 5 minutes before removing the SFP-T transceiver.
- To remove the SFP-T transceiver while the Switch is off, turn off the Switch, and then wait 5
minutes before removing the SFP-T transceiver.
The following label is affixed to the SFP-T transceiver.
Caution: Hot
(During operation, all sides are very hot.)