Instruction manual

MA-2 AX66S-H001X
14
4.12 Connecting interface cables
The explanation about connecting a UTP cable has been corrected as follows.
Correction:
(1) UTP cable
Push the connector until you hear a click.
Figure 4-46 Connecting a UTP cable
(1) UTP cable
(2) Tab
(3) Ethernet port
The above figure shows an example of inserting a UTP cable into the upper Ethernet
port of the network interface unit. Use the same procedure to connect a UTP cable to
the SFP-T transceiver.
To detach the cable, hold the tab down and pull out the connector.
(1) (3)(2)