Instruction manual

MA-2 AX66S-H001X
10
4. Installing a Switch
4.9 Inserting and removing SFP transceivers
The explanation about inserting and removing SFP transceivers has been corrected as follows.
Correction:
SFP transceivers with a network interface unit attached can be inserted and removed while the Switch is on.
4.9.1 Inserting or removing the SFP-SX, SFP-SX2, SFP-LX, SFP-LH, SFP-LHB,
SFP-BX1U, SFP-BX1D, SFP-BX4U, or SFP-BX4D
(1) Inserting an SFP transceiver
Keep the lever upright as shown in the figure, and insert the SFP transceiver until you hear a click.
Figure 4-39 Inserting an SFP transceiver (upper port)
(1) SFP transceiver
(2) Lever
(3) Ethernet port
The above figure shows an example for inserting an SFP transceiver in the upper
Ethernet port of the network interface unit.
If you want to insert an SFP transceiver in the lower Ethernet port, turn the SFP
transceiver upside down and install it as shown in the figure below.
(1) (2)
(3)