Instruction manual

2. Preparation for Installation

can use an optional fixture that secures the Switch so that it is recessed 50 mm

from the rack pillar. For information about this separately sold fixture, see 1.10 Rack

fixture.

Table 2-15 Required brackets

Bracket AX6304S AX6308S Specifications

Guide rail Y Y

Supplied with the rack. The width must

be 56 mm or less.

#1 #2

Shelf Y Y Supplied with the rack.

Support bracket Y -- Sold separately. Only for the AX6304S.

Legend

Y: Can be used.

--: Cannot be used.

#1: Install the guide rail in the location described in 4.5 Mounting in a rack.

#2: Rub

ber p

ads for the Switch are attached 56 mm inward from the side of the

Switch. Use a guide rail with a width of 56 mm or less so that it does not touch the

rubber pads (see Figure 2-11 Guide rail details).

Figure 2-11 Guide rail details

(1) Rubber pad

(2) Guide rail

(3) Rack pillar

It is not possible for the provided rack fixture alone to support the

weight of a Switch. Its purpose is merely to hold a Switch on the rack.

Accordingly, use the following fixtures:

z AX6304S : Guide rails, shelves, and support brackets

z AX6308S : Guide rails and shelves

You must use the guide rails and shelves provided with the rack, and

these must be able to support the weight of a Switch (with the

maximum number of optional modules installed).

Table 2-16 Number of required screws

Purpose AX6304S AX6308S Specifications

When a guide

rail or shelf is

used

For securing

guide rails and

shelves

(Note 1) (Note 1)

Supplied with

the rack. M5 or

M6 screws.