Instruction manual

5. Adding and Replacing Optional Modules

177

Figure 5-37 Installing a network interface unit (4)

(1) Screws

NOTE

Use a screwdriver to tighten the screws. Make sure the screws are

firmly tightened.

NOTE

If you install a network interface unit (NIF) while the Switch is on, the

NIF is turned on automatically when the NIF is installed.

Note, however, that if no power enable is set in the configuration, the

NIF is not turned on automatically. Set power enable, and then turn on

the power.

For details about the power enable command, see 12. Management

of BSU/NIF in the Software Manual Configuration Guide Vol. 1.

5.6.2 Double-size network interface unit

(1) Removing a double-size network interface unit

A network interface unit can be removed while the Switch is on.

Note, however, that the procedure varies depending on whether the Switch is on or

off.

Install the unit while referring to the following figure.

NOTE

For details about steps 1 to 5 in the figure, see the description of the

steps that follow Figure 5-38 Overview of removing a network

interface unit.